Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors) Active Users: 4606 / Visits Today: 3275
Highest Active Users: 4606
Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors)
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 General Information
 The Tractor and Attachment Gallery
 thrust bearings

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

  Click here to attach a photo to your post
 
   

T O P I C    R E V I E W
Mike Dahms Posted - 03/20/2013 : 08:07:48
Hi all. I'm thinking about installing these bearings on the kingpins. Read somewhere there should be grooves cut into the washers to allow grease to flow into the bearing. Can anyone tell me just where this should be done and on what washers. Thanks for the help.
1   L A T E S T    R E P L I E S    (Newest First)
olcowhand Posted - 03/20/2013 : 11:09:11
2 or 3 shallow "V's" on the inside hole of the top washer only. Need only be 1/16" deep or so.

Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors) © Michael's Tractors 2006-2019 Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000
RSS Feed 1